14
SUB SECTION
SUB TO MAIN
- Through these switches, you can operate
the subgroup faders as a master control for assigning the
subgroups to MAIN MIX. Engage the LEFT switch to send the
corresponding subgroup signal to MAIN MIX L, and the
RIGHT switch for MAIN MIX R. When engaging the both
switches, the signal will be sent to L/R of MAIN MIX.
FADERS
- These faders are used to control the levels of the
signal send to the SUB-GROUPS OUT, the adjustable range
goes from - to +10dB. Any channel that is assigned to the
subgroups, not muted and not turned down will be assigned to
the SUB OUTS.
CTRL ROOM SECTION
ROUTING BUTTONS -
You can choose to monitor any combination of MAIN MIX,
SUB1-2, SUB 3-4 and 2TK IN via these Matrix switches. Engaging these switches, the
stereo signals will be delivered to the Phones, Control Room and Meters display.
Note:
When any SOLO switch was engaged, the SOLO signal will replace other signals, and
also be sent to the Control Room, Phones and Meters.
PHONES
- Rotate these
knobs to adjust the output level of PHONES, which can be varied from - to MAX.
CTRL ROOM
- Adjust the knob to control output level of monitor room, which can be
varied from
- to MAX.
AUX RETURNS SOLO
- The function of AUX RETURN SOLO is like the channel
SOLO button. Engaging it sends the signal from AUX RETURN (1-2) to the CTRL
ROOM, PHONES outputs and Meters display. It can also be affected by SOLO mode
button, and the LED next to the button will illuminate.
MAIN SECTION
SOLO MODE
- This button provides two modes: up for PFL (Pre-Fader-Listen) mode,
down for AFL (After-Fader-Listen) mode. Engage the button, the soloed signal will
output after the Level control, otherwise, release the button will output the soloed signal
before the Level control. Note: The SOLO function can never affect the mix at main
recording output, and also can't be affected by channel's MUTE switch.
LED VU METERS
: 12 band stereo LED of VU Meter of console indicates accurately
output level. To reach optimum signal output, control should be set around 0, and send
individually to Ctrl Room and Phones output.
MAIN FADER
- This fader sets the amount of signal send either to the Main Mix
Output or to the Tape Output.
Summary of Contents for Vivo 16 UFX
Page 1: ......
