background image

DE2-EAMSAA200   11.16  Pg. 5

1.800.338.7337 / www.soundoffsignal.com

DE2-EAMSAA200 
200W COMPACT SIREN W/PA FUNCTION

-TESTING AFTER INSTALLATION-

After installation, test all the functions of A200 including the horn 

operation or footswitch if used, to ensure that it is operating properly. 

All effective sirens and horns produce loud sounds (120 dB) that may 

cause permanent hearing loss. Always minimize your exposure to 

siren sound and wear hearing protection. After installation and testing 

is complete provide a copy of this manual to all operating personnel.

-MAINTENANCE-

Your Compact siren has been designed to provide trouble free 

service. In case of difficulty, see the Troubleshooting Guide. A primary 

cause of failure is shorted or open wires. The majority of the short/

open circuits have been found where wiring passes through firewalls, 

roofs, etc. If difficulty persists, contact the factory for troubleshooting 

advice or return instructions, maintain a complete parts inventory 

and service facility at the factory and will repair or replace (at the 

factory’s discretion) any unit found to be defective under normal 

use and in warranty. Any attempt to service a unit in warranty 

by anyone other than a factory authorized technician without the 

express written consent of the factory, will void the warranty. Units 

out of warranty can be repaired at the factory on either a flat rate or 

parts/labor basis. Contact the factory service department for details 

and return instructions. Our company is not liable for any incidental 

charges related to the repair or replacement of a unit unless 

otherwise expressly agreed to in writing by the factory.

PROBLEM

CAUSE

REMEDY

No speaker output

A. Siren not connected
B. Fuse missing/open
C. Speaker wires/speaker shorted

A. Check siren wiring & connections
B. Replace fuse
C. Check siren wiring & connections

Fuse Blows

Power connections reversed

Check power connections

No output from speaker, tones heard 

inside siren amplifier module

A. Speaker not connected, open 
circuit in speaker wiring
B. Speaker failure

A. Check speaker wiring

B. Replace speaker

Siren tones volume too low/garbled

A. Low voltage to siren amplifier

B. Defective speaker/high 
resistance wiring

A. Check wiring for bad connections.  
Check vehicle charging system
B. Check speaker wiring/replace speaker

TROUBLE SHOOTING GUIDE

Summary of Contents for Armada A200






Reviews: