background image

To review  our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product please visit our website at www.soundoffsignal.com and select the “Warranty & Returns” 

link along the left column of our home page. If you have questions regarding this product please contact Technical Services, Monday - Friday, 8 am to 5 pm at 1.800.338.7337, press #4 to 

skip the automated message. Questions or comments that do not require immediate attention may be emailed to [email protected]

1.800.338.7337.  /  www.soundoffsignal.com  / Thank you for trusting us with your safety!

Effective sirens generate loud sound 

pressure levels that can potentially cause 

hearing damage. Installers and those around 

the vehicle need to be aware of the dangers 

and wear hearing protection whenever the 

siren system is operating. Vehicle operators 

and occupants should assess their exposure 

to siren noise and determine what steps 

need to be taken to prevent hearing damage.

The siren system is intended for use by 

authorized personnel only. It is the user’s 

responsibility to ensure they understand and 

operate the emergency warning devices in 

compliance with all applicable city, state, 

and federal laws and regulations.  SoundOff 

Signal assumes no liability for any loss 

resulting from the use of the siren system.

Package Contents:

1 ea.  Amplifier Box 

1 ea.  Microphone Bracket w/ Mounting 

Hardware

4 ea.  Amplifier Wire Harnesses with 

Connectors (1-4 pin, 1-12 pin, 1-5 pin 

and 1-14 pin)

1 ea.  Instruction Manual

1 ea.  Operators Warning Card to remain in 

vehicle for operator review

1 ea.  Sound Pressure Warning Label that is 

to be attached in vehicle and  in plain 

site of operator and occupants of the 

vehicle

1 ea.  Mounting Bracket with Hardware

1 ea.  Label Card for Aux. Switches

Wire capacity requirements for siren 

amplifier (incoming power)-each supply and 

ground wire.

0-10 Feet:  14 AWG

10-20 Feet:  12 AWG

20-30 Feet:  10 AWG

30+ Feet:  Consult Factory to determine 

requirements

380 SERIES REMOTE SIREN

ETSA380R

Please see back page for 
Technical Specifications

ETSA380R   4.12

• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. 

These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these 
devices to ensure compliance.

Important Information:

IMPORTANT NOTICE TO INSTALLER: 

 

Make sure to read and understand all 

instructions and warnings before proceeding 

with the installation of this product.  Ensure 

the manual and all warning cards are 

delivered to the end user of this equipment.

Introduction

The ETSA380R is Remote Mounted Siren 

Amplifier designed for dual 100 Watt 

speaker use. The siren comes standard with 

a noise-cancelling microphone for PA use. 

The amplifier box contains a dual amplifier 

capable of supplying sound to dual 100 Watt 

speakers. The ETSA380R also includes a 3 

position slide switch and 8 independently 

controlled accessory switches each capable 

of supplying 10-20 amps.

The primary operating modes are User 

Selectable tone, Yelp, Wail, Radio, PA, 

Horn Override, and a push-button Manual 

Override are available in all modes. All 

tones except Wail and Yelp for California 

Title 13 compliance may be disabled by 

programming the siren.

Sirens provide an essential function of an 

effective audio / visual warning system. 

However, sirens are only short range 

secondary devices. The use of a siren does 

not insure that all drivers can or will abide 

by or react to an emergency warning signal, 

especially at high rates of speeds or long 

distances. The operator of the vehicle must 

never take the right of way for granted and 

it is the operator’s responsibility to proceed 

safely.

The effectiveness of this siren system is 

highly dependant on the correct mounting 

and wiring. The installer must read and 

follow the manufacturer’s installation 

instructions and warnings in the manual. 

The vehicle operator should verify the siren 

system is securely fastened to the vehicle 

and properly functioning.

!

WARNING

Sirens produce loud sounds that

may damage hearing:

- Roll up windows.

- Wear hearing protection.

- Use only for emergency response.

- Avoid exposure to siren sound

  outside of vehicle.

Control Panel (Universal Bail Bracket 
included - not shown)

Amplifier

Microphone

Summary of Contents for 380 SERIES







Reviews: