SoundMax SM-CSI693, Instruction Manual

Page: 4 / 16

4

If it will be necessary to cut steel, reinstall the cosmetic
panel in place and use the hole you have previously cut as a
template. This will help to insure proper cutting and a good
fit.
Now, mark the locations for the speakers mounting screws,
remove the panel and drill the screw holes. When finished you
may replace the panel.

After cutting and drilling all holes, inspect the mounting
areas for any metal burrs or rough edges. File any area that
may interfere with the mounting of the speaker.
 Clean any metal shavings from the mounting area and
check for areas in which water may enter the speaker cavity.
Treat the area for water protection when necessary.

Place the speaker in the prepared locations by aligning the
mounting holes.

Install the protective grill, also aligning the holes.

Fix the speaker system with the protective grill with the
supplied screws to the installation site without damaging the
frame of the protective grill.
Securing the speakers

Position the speaker into the mounting hole and re-confirm the correct
mounting location and hole placement.

Screw
rings
are provided to ensure a snug fit. These should be placed over the
metal surface and line up the hole you have previously drilled with the screw
ring
. Place the speaker into the hole, align the holes and proceed to insert the
screws. Be sure to tighten the screws evenly so that it will not warp the speaker
frame.

Turn your system back on and confirm the speakers operation first at a low
volume and then you may increase the volume as you desire.

After installation acoustic system and having tested it the speaker grill will have
to be inserted. Turn on you system and follow these steps carefully:
- now carefully inspect the place where the speaker grill will be mounted – there should be no blowholes;