SOUNDMASTER FUR6005, Manual

Page: 13 / 83

FUR6005SW / English Instruction Manual
2
INTRODUCTION
The unit is designed to automatically synchronize its current time and date with radio signal
generated from DCF 77 Frankfurt, Germany.
Power connection
Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery
backup system, it requires a 3V CR2032 flat lithium battery (not included). Insert the battery in
the battery compartment, making certain that the positive and negative (+ and -) battery
terminals are attached to the corresponding terminals on the plate in the battery compartment. If
an AC power failure occurs, the clock automatically switches to the battery power supply, the
clock and timer memory continue running. When the AC power resumes, the clock switches
back to AC again.
GETTING START
Plug the AC power cord to a household outlet AC source.
-
The unit will display full segment for two seconds, then it will enter the normal mode.
- Display will lighten up.
- The unit will start searching radio controlled clock signal automatically.
- The display radio controlled clock Antenna tower will flash.
- Automatically stop after 10 minutes if fail in receiving.
Note:
•
During automatic time search, the device is only conditionally operable (switchable on /
off).
•
Auto search can be stopped by pressing snooze button (13) for 3 seconds.
DISPLAY IN GOOD RECEPTION MODE
- The radio controlled clock Antenna tower icon will keep displaying.
DISPLAY IN POOR RECEPTION MODE
- The radio controlled clock Antenna tower icon will turn off.
1. NOTE:
-
It will take 3-10 minutes to complete.
Note: For best results, place the radio controlled clock antenna (24) away from metal or
electrical objects and near a window with a clear view to the sky.
2. SETTING WITH RADIO CONTROLLED:
-
Not necessary as it is automatically adjusted.
3. SETTING WITHOUT RADIO CONTROLLED MANUAL SETTING:
Can be done when radio controlled clock antenna tower icon is turned off by pressing SNOOZE
button (13) for 3 seconds.
TIME AND CALENDAR MANUAL SETTING
Setting Time and Calendar
A. Press CLK.ADJ. (6) button in standby mode and keep depress over 3 seconds to enter
time set mode, after enter the setting mode, press CLK.ADJ. button (6) to change the mode
cycle as follows
Normal → Year → Month → Day → 12/24 H → Real time Hour → Real time Min → Normal