PL910 / English Instruction Manual
3
PREPARATION FOR USE
UNPACKING AND SETUP
TRANSIT SCREW
Carefully remove the unit from the carton and remove all
packing material from the unit.
Place the unit on a stable level surface, which is
convenient to an AC outlet out of a strong magnetic field.
Raise the lid to expose the phonograph. The phonograph
has been secured for shipment with a transit screw. Use
a coin or screwdriver to turn the transit screw clockwise.
This will allow the turntable to “float”.
Remove the plastic stylus cover from the phonograph
stylus by sliding it in the direction of the arrow. During this
operation pay attention to the stylus, because the stylus
damage is not covered by guarantee.
Remove the twist-tie that was used to secure the tone
arm during shipment.
Release the tone arm lock lever.
Connect the FM / DAB antenna at the back of the unit.
Take the AC/DC adaptor unwind the cable and extend it
to its full length.
Connect the AC adaptor DC plug to the DC jack of the
back.
Installation of counter weight
1. Slide in the counter weight completely into the rear of
the tone arm until it reach the end
，
turn it clockwise
until it click with pit inside.
2. Twist the counter weight clockwise & backward until it
reach the white cross line as figure 2
3.
Hold the counter weight
and twist the
counter
marking
until it reach “0 “ position on top.
4.
Twist the counter weight anti-clockwise & inward until
it reach the appropriate working pressure of 3g.
Remark :
The working pressure of the provided stylus is
from the range 2,5
– 3,5 grams. According to the
cartridge manufacturer. All stylus has it’s own working
pressure and please refer to the specification
respectively.
TONEARM
LOOK LEVER
STYLUS
COVER