Ø
Mount the amplifier in such a way you have access to the connectors;
Ø
Install the power cables in the vehicle properly, starting from the battery to the fuse
holder or circuit breaker, use the cable with the appropriate size. Make all
connections, install fuse holders or circuit breakers, but without placing the fuses
or with the circuit breakers in the "OFF" position;
Ø
Connect the power cables in to the amplifier, observing the polarity. Connect all the
positive cables from the fuse holder or circuit breaker to the positive conector of
the amplifier and all the negative power cables from the batteries to the negative
connector of the amplifier;
Ø
The ground cable must be as short as possible and must be connected to the
vehicle chassis and the battery negative;
Ø
Install the signal input cables in a proper way, distant from the power cables;
Ø
Connect the RCA or the high level signal input cables to the head unit and
amplifiers;
Ø
Install the audio output cables with the appropriate section, distant from the power
and audio input cables;
Ø
Connect the audio output cables to the amplifier and speakers respecting the
positive (+) and negative (-) polarities;
Ø
Install the remote cable with the power cables, using 1.5mm² (15 AWG) cable or
thicker;
Ø
Connect the remote power cable to the amplifier's "REM" terminal at the main unit's
remote power output (when not using the high level signal inputs);
Ø
Before powering the system, verify all the connections and make sure there are no
mistakes or short-circuits on the power and ground cables;
Ø
;
Reconnect the ground of the batteries
Ø
Check if the head unit is turned off and then place the fuses in the fuse holders or
switch the circuit breakers on;
Ø
Turn on the main unit and the amplifier will turn on the "ON" LED indicating that it is
in operation.
INSTALLATION SEQUENCE
Warning!
Warning!
Remove the paint between
the terminal and chassis
11
THE MAXIMUM DISTANCE FOR THE INSTALLATION OF THE FUSE/CIRCUIT
BREAKER IS 12 INCHES (30cm) AWAY FROM THE BATTERY.
