INSTALLATION SEQUENCE
BEFORE INSTALLING ANY ELECTRICAL EQUIPMENT IN THE VEHICLE,
DISCONNECT THE NEGATIVE (-) TERMINAL OF THE BATTERY TO AVOID FIRE,
DAMAGE TO THE AMPLIFIER AND TO THE USER HIMSELF.
CUIDADO!
Ø
Fix the amplifier so that there is access to the connectors.
Ø
Install the power cables in the vehicle in a proper way, starting from the battery up to the fuse
holder or circuit breaker, use the cable with the proper section. Make all connections, install
fuse holders or circuit breakers, but without placing the fuses or with the circuit breakers in the
"off" position.
Ø
Connect the power supply to the amplifier with the correct polarity. Connect all positive
terminals (+) coming from the fuse holders or circuit breakers to the amplifier positive
connectors, and all negative cables (GND) coming from the grounding point to the amplifier
negative.
Ø
The grounding should be as short as possible and should be connected to the vehicle chassis
and the battery negative;
Ø
Install the input signal cables properly, the input signal cables should be installed away from
the power cables.
Ø
Connect the RCA cables to the main unit and the amplifiers.
Ø
Install the audio output cables, with the appropriate cross-section, in a proper manner and
away from the power and audio input cables.
Ø
Connect the audio output cables to the amplifier and speakers respecting the positive (+) and
negative (-) polarities;
Ø
Install next to the power cables the remote power cable with section of 1.5mm² or larger.
Ø
Connect the remote power cable to the "REM" terminal of the amplifier to the remote power
output of the main unit (when not using the high-level signal inputs);
Ø
After the cable connections, before powering up the system, check that all connections are
correct and that there are no shorts between cables and ground cables;
Ø
Reconnect the battery ground;
Ø
Make sure the main unit is off and then set the fuses or turn on the circuit breakers;
Ø
Power up the main unit and the amplifier will turn on the "On" indicator LED indicating that it is
operating.
9
THE FUSE/PROTECTIVE CIRCUIT BREAKER MUST BE INSTALLED NO MORE
THAN 30CM FROM THE BATTERY.
Remove the paint between
the terminal and the body.
CUIDADO!
