Connect black connector to open port on rear of radio
A.
You will be connecting the SoundGate VIDVWTRG1V4 at the factory navigation
radio. Gain access to this location.
B.
Press the locking tab on the black housing adjacent to the black locking arm,
and rotate the locking arm 90°. Insert connector into port on rear of radio and
rotate locking arm back to lock connector in position.
C.
Plug the white 16-pin molex-style connector into the video module.
Preliminary:
A.
Please consult a factory service manual for exact location and disassembly
instructions if you are unsure of the procedure. Pay close attention to any
warnings or instructions regarding working in or around airbags.
B.
Turn the ignition key to the “Off” position.
C.
Make sure the car’s factory radio is turned to the “Off” position.
Step
3
Install the video source unit(s)
Referencing the instructions provided with your video source units,
install the components in the desired locations. Route the video
cables and any required power, ground, and trigger wires to the
factory amplifier location for connection to the VIDVWTRG1V4.
Step
2
Connect audio RCA’s from video source
If applicable, connect the audio RCA’s from your video source to the
RCA’s on the VIDVWTRG1V4 cable.
Step
4
Verify DIP switch settings on VIDVWTRG1V4 module
On the end of the module as shown in the photo at lower left, you will
see a red 5-position DIP switch. Verify that the switches are set as
follows (On =
down
, Off =
up
):
2, 3 = on (down)
1, 4 and 5 = off (up)
Step
1
V
VIID
DV
VW
WT
TR
RG
G1
1V
V4
4 IIN
NS
ST
TA
AL
LL
LA
AT
TIIO
ON
N IIN
NS
ST
TR
RU
UC
CT
TIIO
ON
NS
S
Connect remaining wires
Referencing Figure 2 and 3 on page 3, connect the remaining wires on
the VIDVWTRG1V4 harness. One of the options shown will cover most
installations.
Consult the documentation that came with your video component to determine
which of these is appropriate for your installation.
Step
5
Page 2
IMPORTANT WARNING!
It is illegal in all 50 U.S. states, and in most Canadian
provinces, to have real time video (TV broadcast, VHS, DVD
video, etc.) in view of the driver.
IF YOU ARE GOING TO USE THE SOUNDGATE VIDEO INTERFACE
FOR ANYTHING OTHER THAN INTERFACING A REARVIEW
CAMERA SYSTEM, THE BLUE INTERLOCK WIRE ON THE
SOUNDGATE VIDEO MODULE MUST BE PROPERLY CONNECTED
TO PREVENT THE DRIVER VIEWING REAL TIME VIDEO WHILE
THE VEHICLE IS IN MOTION.
We do not want to put our dealers in a position of liability,
nor our customers in danger in the event of an accident due
to driver distraction.
If you do not intend to comply with applicable law, please
return the SoundGate video module to the dealer it was
purchased from, or to SoundGate if it was purchased direct.
Call SoundGate Customer Service at 800-256-0808 for a
Return Authorization.
DIP switches
Inputs and Controls
Video Input 2
iPod Input
Video Input 1
Brightness/Color/Contrast
/Tint Adjustments
Inputs and Controls
