Page 16
34
32
33
35
31
36
37
38
39
41
40
MASTER SECTION
31
MIX FADERS
The MIX FADERS set the final level of the Mix outputs. The faders should nor-
mally be set close to the 0 mark if the input channel levels have been set correct-
ly.
Pre-fade INSERTS are provided for connection of external processing equip-
ment (e.g. Graphic EQ or compressor/limiters) if required.
32 MATRIX SENDS
The console is provided with two independent Matrix outputs A & B, which
may receive feeds from each Group or Mix Left and Right to create additional
mixes for extra speaker outputs (e.g. side fills, monitors or delays) without affect-
ing the main mix. These knobs control the level of the Mix signal sent to Matrix A
& B buses. They should be turned fully anticlockwise when not required.
Normally the Matrix Sends are derived from a mono sum of Mix L & R.
Pressing the STEREO switch routes Mix L to Matrix A and Mix R to Matrix B to
allow the Matrix outputs to be used as a separate stereo output from the console.
33 MATRIX MASTERS
Each Matrix section has a MASTER control which sets the final output level.
When the AFL switch is pressed, the post-fade signal is fed to the headphones
and L & R meters, where it replaces the normal Mix L/R signal. The PFL/AFL ON
LED on the master section illuminates to warn that the headphones and the
meters are now responding to the PFL/AFL selection and the PFL LED on the
input channel lights to identify the active Matrix output. This is a useful way of lis-
tening to any required output signal without interrupting the main mix, for making
adjustments or tracing problems.
34 TALKBACK
An XLR connector is provided to accept the input from a local talkback mic or
gooseneck mic. Gain is set by the TB LEVEL control and the signal may be routed
to a choice of AUX 1-2, AUX 3-4, MIX or GROUP buses using the four adjacent
switches.
35 POWER ON LEDS
Two LEDs monitor the health status of the console power supply and will be
illuminated when power is connected. Check that both LEDs are lit after turning
on the console power supply.
36 AUXILIARY MASTERS
Each of the Auxiliary Send busses is provided with a rotary MASTER LEVEL
fader and an AFL switch with indicating LED which monitors the final output
after
the fader.
AUX 3 & 4 normally receive post-fade sends from the input channels, but may
be switched to pre-fade by pressing the appropriate AUX PRE switch.
37 PFL/AFL ON
This LED illuminates to show that a PFL or AFL is active on the headphones,
and to show that the Left & Right meters will be displaying the PFL/AFL signal.
38 PHONES
This control sets the level of the PHONES output jack.
