SoundCraft         GicRac1000st, User Manual

Page: 28 / 74

24
2
1
3
Rear Panel
(1) Power Switch
This switch turns the GigRac On or Off. The red Power LED (14) on the
front panel will illuminate to confirm this.
NB! Before switching the GigRac On or Off, make sure
that the Main and Mon Master Volume controls are
turned fully down.
(2) Power Socket
Connect the supplied power cable to this socket.
(3) Speakers Outputs (Amp 1 and Amp 2)
The Speaker Outputs are available as Neutrik Speakon® connectors and
standard ¼” Jack connectors.
The minimum load that either of the amplifiers inside the GigRac 1000st
should be presented with is 4 ohms. this means that a single 4 or 8
ohm speaker can be connected to each amplifier outputs as shown in
Fig 1. Alternatively, two 8 ohm speakers can be connected in parallel to
each amplifier output, as shown in Fig 2. Two speakers connected like
this gives a combined load of 4 ohms.
Use the appropriate connector type to match the input connectors on
your loudspeakers. The GigRac 1000st is designed to work with
loudspeakers rated at either 8 ohms or 4 ohms.
Connect your loudspeakers to these outputs. The signal sent to the
Speakon® connectors and the Jack sockets is exactly the same.