Bridged Mode
When the amplifier is in Bridged mode operation, a single channel (the left) is used to provide a
higher power mono output. Use one channel pair to amplify the left channel by connecting the
left audio signal to the L input of a channel pair, setting the Stereo/Bridge switch to "Bridge" and
connecting the speaker as indicated below. Use a second channel pair for the right channel by
connecting the right audio signal to the L input of a second channel pair, setting the Stereo/Bridge
switch to "Bridge" and connecting the speaker as indicated below
Wiring Instructions - Bridged Mode
* Turn off the amplifier and connect an 8-ohm minimum load.
* Set the Stereo/Bridge switch to Bridged Mode.
* Follow the Bridge mode markings on the back of the amplifier:
Connect the negative lead (-) of the speaker cable to the R– terminal.
Connect the positive lead (+) of the speaker cable to the L+ terminal.
* Apply the Line In from audio source to the Left Line In connector.
* Power on the amplifier.
DVD
7
Bridge
L+
L-
R-
R+
+
-
Speaker
