Page 3
Page 6
11. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and then
returns to its previous display.
Press the CLK button and hold for more than 1 second until the time flashes on the
display. Then you can adjust HOUR or MINUTE by press the VOL- or VOL+ button .
12. LOC BUTTON
Radio station search mode is divided by this LO/DX switch, this button can be
used to control an attenuator in the tuner during search. The detecting level
of seek, scan, auto-memory will be reduced as much as the attenuated level
of the tuner. In radio mode, press the LOC button to change local reception or
distance reception.
Note: This button is only active for FM reception.
13. LOUDNESS BUTTON
When press briefly, the LOUD mode is turned on, its to enhance the bass sound
effect when the volume level is low. Press again to cancel the loudness effect.
14. ST/MO BUTTON
In FM mode, press the ST button briefly to select stereo or mono sound mode.
15. AS/PS BUTTON (Auto-storage /Preset scan)
During radio mode:
1) When press and hold for more than 1second, the radio searches from the current
frequency and checks the signal strength level until 6 station are found. And then
the 6 stations frequency are preset to the corresponding preset memory numbered
bank. The auto-storage operation is implemented in each selected band. When
the auto-storage operation is finished, the radio execute the Preset scan.
2) When press briefly, the radio searches for each preset station in the current band
and plays that preset station for 5 seconds, and then searches again.
During SD/MMC or USB mode:
TRACK SEARCH mode:
Press the AS/PS button to enter track search mode.
In track search mode, the LCD display TRK 000 and flash the highest digit 0 which
the SD/MMC card or USB stick contain.
Press the VOL+ or VOL- buttons to select number of the flashing digit from 0 to 9,
and then press the BAND button to confirm the number and flash the next lower
digit 0. Following the same steps as above, choose and confirm the digits until the
desires track number has been selected and press the BAND button to start playing
the track.
FIRST CHARACTER SEARCH mode:
In first character search mode, the display will show the files in alphabetical order
from A to Z and 0 to 9. If the files are not saved by character names the unit will
display
“NONE”
on the screen. Use the VOL+ or VOL- buttons to search through
the files and press the SEL button to play the desired file.
TROUBLE SHOOTING
Before using the check list please make all the connections first.
If you still have questions after going through the checklist, please consult
your local customer service representative.
Common Symptoms
There is no power.
Cause
The fuse has blown.
The volume control is set too low.
There is no sound.
The operation keys
do not work
The antenna cable is not connected.
Insert the antenna cable firmly into the
antenna socket of the device.
No radio reception.
The built-in microcomputer is not
operating properly due to noise
Switch the device off and on again. Or press
the RESET button to reset the unit.
The device has not been wired
correctly.
Turn up the volume properly.
Check the power and ground connection
according to the wiring diagram.
Replace another fuse according to the wiring
diagram.
The car ignition is switched off.
If the power supply is properly connected to
the car accessory, switch the ignition key to
ON or " ACC
"
"
" .
Solution
In automatic search
mode the radio does
not stop at a trans-
mitting station.
Tune in to a radio station manually.
The transmission signals are too
weak.
Summary of Contents for ML33USA
Page 1: ......
