www.soundskulptor.com
Document revision 1.1 – Last modification : 07/01/15
V12V2 Adapter board - Assembly guide
V12V2 Adapter board - Assembly guide
V12V2 Adapter board - Assembly guide
V12V2 Adapter board - Assembly guide
6.
6.
6.
6.
Spacers
Spacers
Spacers
Spacers
Attach 2 10mm nylon spacers, below PCB, with 2 M3x6 screws on each
side of CN2.
7.
7.
7.
7.
Wires
Wires
Wires
Wires
For MP12, MP32, MP73 cut two blue/red pairs of 8cm wires.
For MP66 cut one 8cm pair and one 17cm pair of blue/red wires.
Strip 5mm of one end of each wire.
Solder the red wires at the bottom side of the PCB on the IN+ and OUT+ pads. Long wire on output
for the MP66.
Solder the blue wires at the bottom side of the PCB on the IN- and OUT- pads. Long wire on output for
the MP66.
Pass the wires through the corresponding holes.
Strip 15mm of the end of each wire and twist the wires by pairs.
8.
8.
8.
8.
Check
Check
Check
Check
After your board has been stuffed, brush the solder side with a hard tooth brush to remove any remaining
solder bits.
Make a full visual check. Any missing component on the board ? Any remaining component in the box ?
9.
9.
9.
9.
Installation
Installation
Installation
Installation
plug the V12V2 adapter board
on the corresponding SKMP
connector. One V12V2 board is
needed for each mic pre.
10.
10.
10.
10. Connections
Connections
Connections
Connections
Plug in the 26 conductors ribbon cable between the V12V2 adapter and the mic pre board.
Connect the input and output wires between the V12V2 adapter and the mic pre terminals :
Red left to Input+
Blue left to Input -
Red right to
Blue right to Output -
Copyright ©2011-today SoundSkulptor
