11
6
Wireless system set-up.
Each transmitter and receiver pair must be the same channel. The Shure wireless
system uses transmitter setup to synchronize the transmitter and receiver channels.
Note: transmitting devices such as cellular phones may interfere
with wireless audio transmissions. Keep transmitters and receiv-
ers away from these and other potential sources of interference.
Single wireless system set-up.
1. Automatic Channel Scan: Press and release the group button on the
receiver. This scans for a clear channel and sets the receiver to that
channel.
2. Transmitter Setup: Transmitter group and channel must be manually set to
match the receiver.
After manual setup, the transmitter alternately displays the group and
channel setting for about two seconds.
Transmitter Locking Feature
Turn the transmitter on. Hold the group button, then press the channel
button for approximately 2 seconds. The LED indicator rapidly flashes
red when locked. Repeat to unlock. This feature keeps users from
changing the channel accidentally.
1. Press and release the
group
button to activiate
the display. Press the
group
button again and
the display flahes.
Choosing an input.
Plug a microphone with an
XLR connector into mic input
one or two. The knob above
the jack controls the volume
level.
The mic inputs are balanced and
low impedance, and supply phantom
power (10 volts) for condenser type
microphones.
When using long mic cables, use a
balanced microphone to help prevent
hum and interference.
Plug a balanced, line-level
source with an XLR connector
(such as the output from a
mixer) into line input one. The
knob above the jack controls
the volume level.
Line input one is a balanced line level
input.
Use shielded cable to avoid hum or
interference.
To daisy-chain two sound systems
together for greater crowd coverage,
connect the line output from one
system into line input one.
L
Group (letter)
If channel needs to be changed, follow the same
procedure using the
channel
button instead of the
group
button.
2. While the display is flashing, press the
group
button again to advance to the desired group set-
ting.
Channel (number)
