5
Power Wire (BAT+)
•
Disconnect the negative battery
terminal before proceeding. Call
1-800-955-9094 for instructions if
you are unsure.
•
Plan wire routing before cutting
any wires to length. Begin by rout-
ing the power BAT+ wire from the
battery to the subwoofer location.
Use a grommet when running wires
through the rewall or metal open-
ings. Avoid running the power wire
near existing vehicle wiring to
prevent induced noise from entering
the audio system.
•
Exercise caution when drilling
holes to avoid damaging fuel lines
or existing vehicle wiring.
•
The BAT+ wire MUST be fused within
18” of the battery for protection
of the vehicle’s electrical system.
Ground Wire (GND)
•
The subwoofer’s ground wire should
be as short as possible. Choose a
clean unpainted section of metal or
the vehicle chassis when attaching
the ground connection. Be sure
to clean the area of any dirt or
grease.
Remote Turn-on Wire (REM)
•
The remote turn-on wire connects
to the head unit’s amplier turn-
on lead or other switched 12-volt
source.
Input Signal
•
The subwoofer’s input signal con-
nects to the head unit’s low level
(RCA) or high level (speaker wire)
outputs.
•
Dedicated subwoofer or low level
inputs signal deliver the best
performance. If unavailable, use
the high level inputs - when
interfacing with factory head unit
for instance. Be sure to observe
the correct polarity when using the
high level inputs.
CONNECTIONS
Do not use both low and high level inputs at the same time -
connect only one or the other.
Never run any wires underneath or outside the vehicle.
NOTE: Be sure to follow specic instructions included with your am-
plier installation kit (not included with this powered subwoofer). The
information below should be used a general guideline only.
!
