Sound Magus H500, Owner'S Manual

Page: 11 / 12

9
10
TROUBLE SHOOTING
If your amplifier is still malfunction after checking through the troubleshooting
section
,
please contact our authorized SOUNDMAGUS dealer
.
Power LED off
No Output
(
Power LED on
)
No Output
(
Protect LED on
)
Distorted Output
Amplifier switches
on and off
MALFUNCTION SOLUTION
One Channel has
as no function
Check volume control on the source unit
Check GAIN regulator on amplifier
Check RCA cables and connections
Check speaker cables and connections
Check connetions both at amplifier and at other ends
Check plus and minus battery cables
Check all fuses on amplifier
Check remote voltage
Speaker is short circuit or damaged
Amplifier is over temperature
Amplifier is over loaded
Battery is low voltage
Source unit gain set too high
Amplifier gain set too high
Speaker
(
s
)
blown
Check chasis ground connection with amplifier
Check cable terminals and battery terminals
Low voltage from battery
Check the connection of the remote wire
Check RCA connections of this channel
Check speaker connection of this channel
Balence regulator of source unit do not set in middle
Speaker of this channel is damaged
SPECIFICATION
RMS
@4Ω(
Power supplier
14.4V)
4
×
90W
+
300W
Input Level 0
.
2V
-
5V
4x channel Frequency Response 20Hz
-
25KHz
4x channel HPF Frequency 20Hz
-
200Hz
Subwoofer Channel frequency response 8Hz
-
200Hz
Subsonic Filter Frequency 8Hz
-
50Hz
LPF frequency 40Hz
-
200Hz
The size of the whole machine Dimension
383mm×228mm×52mm
RMS
@
2
Ω(
Power supplier
14.4V)
4
×
120W
+
500W
THD at 4ohm load 30% rated power <0 05%
.
S
/
N Ratio
Optional remote control YES
Overload protect system YES
Overheat protect system YES
RMS
@
4 Bridged power
Ω (
supplier 14
.
4V
)
2
×
200W
+
300W
4x Channel Bridged
>89dB
Enable in same group