5
p e r s o n a l s o u n d s y s t e m
GETTING STARTED
Charging the PSS
The PSS uses rechargeable
batteries. Before use, charge for
5 hours. To charge, place device in the appropriate
slot in the Charging Cradle. When charging, the
status light will be red. If the status light does not
light, make sure the device is properly and securely
placed in the correct slot in the Charging Cradle.
When fully charged, status light will turn green.
NOTE: Putting the device into the Charging Cradle will
automatically turn it OFF.
Pairing the Ear Module with
a Bluetooth
®
Mobile Phone
The PSS requires a Bluetooth
®
-enabled mobile
phone. Check your phone’s User Guide to determine
if you have Bluetooth technology.
It is necessary to first “pair” the Ear Module with
your Bluetooth-enabled phone in order for them to
communicate wirelessly. Once pairing is complete and
the devices are within range (30 feet) of each other
and switched ON, they will be able to communicate
with each other. Pairing is done once and normally
there is no need to repeat the pairing process.
To initiate pairing, turn the Ear Module OFF. Then
press and hold the main button on the Ear Module
for 8-10 seconds until you see the status light
flashing alternating green and red.
With the mobile phone ON, follow the manufacturer’s
instructions for pairing.When asked to look for devices,
Select SOUND ID. The phone will seek Sound ID and
ask to bond with the device. Select YES.
You will be asked for a PASSCODE, PASSKEY or PIN
CODE. Enter OOOO. The phone will automatically
verify PIN and connect with the PSS.
