To turn it ON:
Press and hold the Main Button for approximately three
seconds. The status light will flash green when the headset is on.
To change the volume: Most handsets will allow you to change
the headset volume using the volume control on the phone. In this
case the Sound ID 200 remembers the new volume level.
The volume can also be changed on the headset. The headset has
four volume settings which can by cycled through by pressing the volume
button briefly for each step. You will hear a beep at the maximum volume
step; upon the next press, the volume goes back to lowest step.
To answer a phone call:
Press the Main Button when the Sound ID
200 rings.
To end a phone call:
Press the Main Button.
To make a phone call:
Use the mobile phone to initiate the call. The
audio will automatically transfer to your Sound ID 200 headset.
To turn it OFF:
Press and hold the Main Button for three seconds.
The status light will turn red when the headset turns off.
To turn NoiseNavigation
™
ON/OFF:
To turn all noise reduction off,
press and hold the Volume button for two seconds until you hear two
beeps. To turn noise reduction back on, press and hold the Volume
button until you hear one beep.
How It Works
2
Summary of Contents for 200
Page 45: ...Notas ...
Page 67: ...Remarques ...
