Page 9 of 9
NOTE:
Do not use multiple speaker outputs at the same time. Only connect the speakers to one of the following outputs:
4 ohm, 50V, 70V or 100V terminal. Impedances indicated in the figures represent the total speaker system (load) impedances.
Speaker Connections
XLR Connections
70V LINE
50V LINE
4
70V 100V
COM 4
50V
70V 100V
COM 4
50V
70V 100V
COM 4
50V
100V LINE
70V 100V
COM 4
50V
(T-60FP)
(T-120FP)
42
21
(T-60FP)
(T-120FP)
81
41
(T-60FP)
(T-120FP)
167
83
WARNING
| Be sure to attach the supplied terminal cover after connecting the speaker cabling. High voltage
is applied to the speaker terminals, never touch these terminals to avoid electric shock.
OPERATION NOTE
| Do not turn mixer amplifier on and off frequently. You should allow 10 seconds after
turning off the device, before turning it back on. Ensure the power supply matches the requirements listed
on the back of the device. Always operate this device with AC ground wire connected. If the device goes into
protection mode for any reason, it will auto-check and restart automatically if the issue has been resolved.
