7. Tighten the Euro connector's screws once the wires are inserted.
8. Connect the Euro connector into the back of the speaker.
9. Select the appropriate wattage tap with the wattage tap dial.
NOTE:
the wattage tap dial has no effect when wired to the 8 ohm terminal. This bypasses
the internal transformer.
CAUTION: Never use a 25/70 volt amplifier with the speaker wired to the 8 ohm
terminal. This will destroy the speaker voice coil and void your warranty.
Spring Clip installation:
CAUTION:
The spring clips can snap back causing injury to fingers and/or hands.
Wear
protective gloves.
1.
IMPORTANT:
Use two hands to hold the speaker and spread the spring clips open using
your thumbs with the back of the speaker facing the ceiling.
2. Place the back of the speaker half way into the cut-out hole or until the top of the spring
clip clears the rough-in bracket.
3. Release the spring clips.
4. The force of the spring clips will cause the speaker to slide up into the cutout hole.
5. Place you hand on the front of the speaker and lightly push up until the speaker is seated
and the grill surround is flush to the ceiling tile.
Contact Information
Sound Acoustics HQ
1360 Frances Street
Vancouver BC Canada V5L 1Y9
E-mail: [email protected]
Website:
www.mysoundacoustics.com
Warranty
Sound Acoustics products are warranted to be free from defects in workmanship and materials for
a period of ten (10) year without charge for parts or labour. The warranty applies only to the
original owner. The owner’s responsibilities are to provide proof of purchase and transportation to
the dealer the unit was purchased from or transportation to the Sound Acoustics factory. This
warranty does not apply to units which have been subject to misuse, abuse, neglect or improper
installation, and does not apply to repairs or alterations by unauthorized personnel. This warranty
specifically excludes responsibility for consequential damage.
Retention of your dated ORIGINAL BILL OF SALE is required to obtain service under the terms of
the warranty.