③
④
①
②
⑤
⑥
⑦
Product outline
①
USB port 1 : connect USB device.
②
Power switch of USB port 1 : Switch ON if the connected USB device requires USB power. Otherwise, switch OFF.
③
USB port 2 : Connect USB device.
④
Power switch of USB port 2 : Switch ON if the connected USB device requires USB power. Otherwise, switch OFF
⑤
External power input jack : Connect the external power of 6.5Vdc ~ 9Vdc, 2A to feed external power. (5.5mm OD, 2.1mm ID)
⑥
Internal USB port connector : Connect to the computer main board USB header connector by the internal USB cable and the gender changer.
⑦
Internal power connector : Connect to the SATA power cable inside of PC.
Precaution
Recommend using one of USB ports only. If you use both USB ports at the same time, sound quality may degrade.
How to use
tX-USBhubIn is 2 ports USB2.0 internal hub designed for the best USB audio performance.
Install one of the supplied brackets to the products according to the height of PC case.
-
The slim size bracket is assembled with the product, so if the PC case is the slim size, don’t need to change the bracket.
-
If the PC case is the standard size, unscrew the slim size bracket and replace to the standard size bracket and fasten the screws.
Open the PC case and place the product into the empty card slot. Fasten the product bracket by using the screws of PC case.
Connect the internal USB port connector of the product to the USB header connector of the computer main board.
-
Use the internal USB cable and the gender changer to connect them accordingly.
Caution
: A mark ▼ on the gender changer should be located to the no.1 or no.2
position of the mainboard USB header connector. You should check the direction of the
no.1 position of the main board USB header connector and make connections. Normally,
the no.1 position of 10pin USB header connector is located opposite side of ‘No pin’
direction or the no.1 position is marked as a thicker line or printed as no.1.
-
If the pitch of main board USB header connector is 2.54mm like a standard main board, use the 2.54mm gender changer.
-
If the pitch is 2.0mm like a Intel NUC board, use the 2.0mm gender changer.
-
Connect the product to the main board by the gender changer and the internal USB cable.
Connect SATA power cable to the internal power connector of the product.
Connect 6.5Vdc ~ 9Vdc, 2A power to the external power input jack if wanted to use the external power.
-
Disconnect the internal power conection if used the external power.
Place USB power switch to OFF if the USB device doesn’t use +5V of USB port.
Close the PC case and connect one of USB ports of the product to a USB device by external USB cable.
The product will be recognized and operate automatically without the driver installation once PC is powered on.
USB Header
USB Gender
Computer main board
tX-USBhubIn
SATA Power cable
Internal USB cable
External USB cable
