16
Halkey-Roberts V86160 Manual Inflator
ReArming/Status Indicator Instructions
DISASSEMBLY
(see figure)
Step 1
: Unpack or open the life vest so that the manual inflator is visible.
Step 2
: Remove gas CO2 cylinder by rotating cylinder
counterclockwise then pull out.
Discard cylinder.
REARMING
Note: Rearming must follow the sequence below.
Step 3
: Check the new cylinder to be sure it has
sensor ring attached.
Step 4
: Install new cylinder by engaging bayonet tabs in housing,
pushing in then turning clockwise 1/8 turn to a full stop.
WARNING: PFD WILL ONLY INFLATE IF
CYLINDER IS TURNED TO FULL STOP.
Step 5
: Check to be sure service indicator is green.
Service Indicator
If green, unit is operable.
If red, stop and service unit.
Sensor Ring
Step 3
Bayonet
Tabs
Step 4
Service Indicator
Step 5
CO2 Cylinder
Step 2
Note: Right and Left hand models
pictured above. Your inflator will
look like either the left or right image.
print run id
Summary of Contents for 24MSPT-1
Page 2: ...2...
