Loop
SORG
22
2.5
ASSEMBLY GROUP LEG SUPPORT
ATTENTION
LEG SUPPORTS WITH A DIVIDED FOOTREST ARE NOT
SUITABLE FOR USERS WITH TONE DYSREGULATION
2.5.1 Positioning the leg supports
All leg supports are mounted under the seat plate, which is
shown transparent here. You have two scenarios available
with which you can adjust the distance of the adapter to the
seat shell.
1. Displacing the leg support adapter:
• (1)
If necessary, you must move the wedge
adapter (here displayed transparent), so that
through the mounting holes
(A)
the holes un-
derneath
(2A)
between adapter
(2B)
and seat
plate are accessible.
• Remove all four screws
(B)
and
• move the wedge adapter as stated above.
• (2)
Remove the screwing
(A)
between adapter
(B)
and seat plate on both sides,
• move the adapter
(B)
along the drilled holes
(C)
(= per hole about 2 cm),
• replace the screwing
(A)
back through the seat
plate and retighten the screws.
• Correct the position of the wedge adapter and
• screw it back on to the seat plate tightly.
2. Displacing the leg support in the adapter:
• (3)
Loosen both screws
(B)
on the leg support
adapter
(A)
and slide the leg support bars in
the desired position.
• Retighten both screws
(B)
.
• (4)
When it comes to the leg supports which
swing to the side, loosen the headless screw
(A)
• push the leg support bars
(B)
in the desired
position and
• retighten both screws
(A)
.
• (5)
So that the top end of the leg support bars
(A)
is stabilized under the footrest, two square
tubes
(B)
are mounted under the seat plate.
INFORMATION
(5) The end of the leg support bar must always overlap the
stabilizing tube at least 1 cm.
ATTENTION
After every change on the leg support be sure to make
sure that the casters can freely turn 360° by maximum
tilting. If necessary, make corrections on the casters or
on the leg support.
(2)
(1)
(B)
(C)
(C)
(A)
(A)
(A)
(B)
(B)
(A)
(B)
(C)
(C)
(3)
(5)
(A)
(B)
min. 1 cm
(A)
(B)
(4)
