Soozier A61-022 Assembly & Instruction Manual Download Page 3

IMPORTANT SAFETY NOTICE

 

know and follow these rules for safe operation of the system. To ensure safety, do not attempt to 
assemble this system without following the instructions carefully. Check entire box and inside all 
packing material for parts and/or additional instruction material. Before beginning assembly, 
read the instructions and identify parts using the hardware identifier and parts list in this 
document. Proper and complete assembly, use, and supervision are essential for proper 
operation and to reduce the risk of accident or injury. A high probability of serious injury exists if 
this system is not installed, maintained, and operated properly.
• If using a ladder during assembly, use extreme caution.
• Two (2) capable adults are recommended for this operation.
• Check base regularly for leakage. Slow leaks could cause system to tip over unexpectedly.
• Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to 
  separate during play and/or transport of the system.
• Climate, corrosion, or misuse could result in system failure.
• This equipment is intended for home recreational use only and NOT excessive competitive 
  play.
• Read and understand the warning label affixed to pole.
• The life of your basketball pole depends on many conditions. The climate, placement of the 
  pole, location of the pole, exposure to corrosives such as pesticides, herbicides, or salts are all 
  important.
• If technical assistance is required, contact Customer Service.
• Adult supervision is recommended when adjusting height.

AILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN S

ERIOUS INJURY ORPROPERTY DAMAGE AND WILL VOID WARRANTY. 

Summary of Contents for A61-022












Reviews: