7
Section 2
Service Note
2-1. Operation Notes
2-1-1. Flexible Board
•
Make sure that the conductive side of a flexible board does not have any stain or foreign materials.
•
Do not touch the conductive side of flexible boards with bare hands.
•
Plug in a flexible board straight, fully into the connector until it reaches the end inside.
•
When opening the connector's holder in direction A, do not open it with excessive force.
•
When closing the connector's holder, press it evenly while pushing a flexible board in direction B.
•
Make sure that the flat cable and flexible board are not cracked or bent at the contact end.
•
Do not apply excessive force to the gilded flexible board.
2-1-2. Fine-Wire Coaxial Cable
•
The proper way to disconnect a connector is to grab the connector instead of the wires. If you pull on the wires, they might be
broken.
•
The proper way to connect a connector is to grab the connector instead of the wires. If you push on the wires, they might be
broken.
Flexible
Board
Flexible
Board
Connector
Connector
Reference line
Flexible
Board
Connector
Connector
Flexible
Board
Reference line
Connector
Connector
Flexible
Board
Flexible
Board
Reference line
OK
(The flexible board was plugged in
straight and completely)
(The flexible board was plugged in
crooked.)
NG
NG
(The flexible board was not plugged in
completely.)
Holder
Connector
Flexible Board
A
A
Holder
Insulation side
Connector
Flexible Board
B
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
Sony CONFIDENTIAL
For Authorized Servicer
SYS SET
2020/05/28 23:46:49 (GMT+09:00)
