Sony XR-C5110R, Service Manual

Page: 21 / 44

– 25 –
– 26 –
6-4. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Printed Wiring Board:
• X : parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
• b
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
¢
: internal component.
•
C
: panel designation.
•
U
: B+ Line.
•
H
: adjustment for repair.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : FM
(
) : AM (MW/LW)
〈〈 〉〉
: TAPE PLAYBACK
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : FM
f
: AM (MW/LW)
L
: BUS AUDIO IN
E : TAPE PLAYBACK
• Waveforms
– MAIN Board –
1
IC1
2
(OSC OUT)
2 IC51 5 (OSCI)
3 IC501 &¢ (XOA)
4
IC501
(£
(X1)
0.8 Vp-p
97 ns
3.3 Vp-p
230 ns
3.6 Vp-p
30.6
µ
s
5.8 Vp-p
272 ns
2.7 Vp-p
27
µ
s
– KEY Board –
1
IC901
^º
OSC