Sony XR-C5080R, Service Manual

Page: 14 / 38

– 14 –
SECTION 4
MECHANICAL ADJUSTMENTS
• Tape Tension Measurement
1. Clean the following parts with a denatured-alcohol-moistened
swab:
playback head pinch roller
rubber belt capstan
idler
2. Demagnetize the playback head with a head demagnetizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to the
parts adjusted.
5. The adjustments should be performed with the power supply
voltage unless otherwise noted.
• Torque Measurement
See the adjustment location from on page 17 for the
adjustment.
0 dB=0.775 V
TAPE DECK SECTION
Speed checker Frequency counter
–1.5 to +2.5% 2,955 to 3,075Hz
SECTION 5
ELECTRICAL ADJUSTMENTS
Mode Torque Meter Meter Reading
Forward CQ-102C
30 - 65 g•cm
(0.42 - 0.90 oz•inch)
Forward
CQ-102C
0.5 - 4.5g•cm
Back Tension (0.01 - 0.06 oz•inch)
Reverse CQ-102RC
30 - 65 g•cm
(0.42 - 0.90 oz•inch)
Reverse
CQ-102RC
0.5 - 4.5g•cm
Back Tension (0.01 - 0.06 oz•inch)
FF, REW CQ-201B
60 - 200 g•cm
(0.83 - 2.78 oz•inch)
Mode Tension Meter Meter Reading
Forward CQ-403A
more than 90 g
(more than 3.18 oz)
Reverse CQ-403R
more than 90 g
(more than 3.18 oz)
TEST MODE
This set have the test mode function. In the test mode, FM Auto
Scan/Stop Level and AM (MW) Auto Scan/Stop Level adjustments
can be performed easier than it in ordinary procedure.
<Set the Test Mode>
1. Set the “power select” switch (S801) is “A” position.
2. Turn ON the regulated power supply. (All LEDs on the set
lights up, and the clock is displayed.)
Note:
Press the
[OFF]
button, if the clock is not displayed.
3. Push the preset
[4]
button.
4. Push the preset
[5]
button.
5. Press the preset
[1]
button for more than two seconds.
6. Then the display indicates all lights, the test mode is set.
<Release the Test mode>
1. Push the
[OFF] button.
2. Return the “power select” switch (S801) to initially set posi-
tion.
Tape Speed Adjustment
Setting:
Adjustment Location: See page 17.
set
+ –
test tape
WS-48A
(3 kHz, 0 dB)
speaker out terminal
4
Ω
speed checker
or
frequency counter
Procedure:
1. Put the set into the FWD PB mode.
2. Adjust adjustment resistor for inside capstan motor so that the
reading on the speed checker or frequency counter becomes in
specification.
Specification: Constant speed