20
Mode Settings
Partial Scan Mode
You can increase the frame rate by setting the upper
high-speed transfer (FPS) and the lower high-speed
transfer (RPS) via the RS-232C interface. When the
RS-232C ON/OFF switch is set to OFF, you can set
the 1/2 partial scan mode or 1/4 partial scan mode by a
combination of switch 5 and switch 10 located on the
rear panel.
The image is centered as shown below.
X lines
960 lines
Notes
• In trigger shutter mode, video out signals are output
about 1 H later than the external VD.
• In partial scan mode, image output and the WEN
rising edge are always synchronized, but the WEN
width becomes undefined.
Dip switch setting
Operating mode
Switch 5
Switch 10
1/2 V partial scan
1/4 V partial scan
