34
Camera Control Command
Command
Parameter range
Description
PARTIAL[CR]
None
Reads the partial scan mode setting
AREA FR[CR]
F: 0 to F (Hexadecimal numbers)
Sets the partial scan area
R: 0 to F (Hexadecimal numbers)
The parameters are indicated by hexadecimal numbers. The number of
blocks transferred at the upper high-speed is indicated by the first digit,
and the number of blocks transferred at the lower high-speed is indicated
by the second digit. Set the area within the range of F + R < 16.
AREA[CR]
None
Reads the partial scan area
MODE P[CR]
P: 0 to 3
Sets the trigger mode.
0: OFF
1: Restart/Reset
2: Trigger Mode 1
3: Trigger Mode 2
MODE[CR]
None
Reads the trigger mode
VERSION[CR]
None
Reads the version of the firmware of the camera
Maa,dd[CR]
aa: 00 to FF (Hexadecimal numbers)
Writes the data indicated by the parameter in the user memory
dd: 00 to FF (hexadecimal numbers)
Maa[CR]
aa:00 to FF (hexadecimal numbers)
Reads the user memory
FRATE P[CR]
P: 0 to 1
Sets the frame rate
0: 30 fps
1: 15 fps
FRATE[CR]
None
Reads the frame rate
INTEXT P[CR]
P: 0 to 1
Sets the synchronous mode
0: INT
1: EXT
INTEXT[CR]
None
Reads the synchronous mode
TERM P[CR]
P: 0 to 1
Sets the 75-ohm termination of the VD/HD input
0: 75-ohm termination OFF
1: 75-ohm termination ON
TERM[CR]
None
Reads the setting of the 75-ohm termination of the VD/HD input
