5
Connection Diagram
XCK-L555 Angle Case Kit
The XCK-L555 allows you to bend the XC-505/505P 90
degrees horizontally (HL).
You can install XC-505/505P in only HL (horizontal)
directions. VL (vertical) is not available with this model.
Dimensions
Angle type
On the upper position of the Front block
z
is located. Set
the direction correctly while looking at the Front block
from the front so that
z
is in the upper position.
Dip switch: rear
Installation
Use angle case A/B and screws.
1
Remove the four screws (+PM1.7 × 3) from the front
panel.
The front block will pop out due to pressure from the
flexible cable.
2
Attach the angle case (B) to the underside of the front
block.
Do not pull the front block out forcibly. If you do so,
you may damage the flexible cable.
3
Attach the angle case (A) to the front block.
Note
22
8
22
28
85.3
74.3
505HL
UNIT: mm
Note
Front
block
Camera case
Flexible cable
Angle case (B)
Angle case (A)
