10
Preparations
tuner unit is equipped. The WRR-855S can
be attached to the Camcorder using that
slot.
For details on how to attach the WRR-855S to the
Camcorder, refer to the Operation Manual supplied
with the Camcorder.
Using a Portable Tuner
Mount Adapter
This section shows you how to mount the
WRR-855S to the BTA-801 Portable Tuner
Mount Adapter (not supplied) for example.
By properly mounting the WRR-855S to
the BTA-801 and attaching the two
supplied antennas, a weatherproof structure
is obtained.
To mount the tuner unit to the
portable tuner mount adapter
Before mounting, be sure to clean the
abutting surfaces of the WRR-855S and the
BTA-801.
1
After observing the direction, insert
the WRR-855S in the BTA-801.
2
Push the WRR-855S down until the
accessory connector clicks into place.
3
Run in the four mounting screws little
by little in turn to gradually secure the
tuner unit and the adapter together,
then tighten them.
To connect the power cable
Connect the DC 12 V IN connector of the
BTA-801 to the DC OUT connector of the
Camcorder using the DC power cable
supplied with the BTA-801.
To remove the power cable
Pull the metal part of the connector in the
direction of the arrows and remove.
Note
WRR-855S
BTA-801
BTA-801 (bottom)
Match the
connector pins
with the connector
inside and insert.
DC power cable
(supplied with the
BTA-801)