22
AV2 OUTPUT
The "AV2 Ouptut" option allows you to select the source to be output from the Scart connector
2
/
2
so that you can record from this Scart the signal coming from the TV or the signal that is being viewed
on the TV.
If your VCR or DVD recorder supports SmartLink, this procedure is not necessary.
To do this:
Once you have entered into the "Features" menu as it is explained in the previous page and after selecting the option,
press
OK
. Then press
v
or
V
to select the desired output signal:
TV
to output the aerial source.
AUTO
to output the signal that is being viewed on the TV.
• If you select “AUTO”, the output signal will always be the same one that is displayed on the screen.
• If you have connected a decoder to the Scart
2
/
2
or to a VCR connected to this Scart, please
remember to change back the "AV2 Output" to “TV” for correct unscrambling. Alternatively, set the
"Decoder" option in the "Manual Programme Preset" menu to "On" for the scrambled programme. For more
details refer to page 26.
TV SPEAKERS
This option allows you to turn off the TV speakers e.g. to listen to the sound through external audio equipment con-
nected to the TV.
To do this:
Press the
v
or
V
buttons to select one of the following options, then press the
OK
button.
On
The sound is output from the TV speakers.
One Time Off
The TV speakers are temporarily turned off allowing you to listen to the sound from external
audio equipment.
The "TV Speakers" option automatically returns to "On" when the TV set is switched off.
Permanent Off
The TV speakers are permanently turned off allowing you to listen to the sound from external
audio equipment.
To turn on the TV speakers again, change the "TV Speakers" option to "On".
RGB CENTER
This option is only available if an RGB source has been connected to the Scart connectors
1
/
1
and
3
/
3
on the rear of the TV.
When viewing an RGB signal, the picture may need some adjusting. This option allows you to adjust the horizontal
picture position so that the picture is in the middle of the screen.
To do this:
Once you have entered the "Features" menu as it is explained in on page 21 and while watching an RGB source select
the “RGB Center” option and press
OK
. Then press
B
or
b
to adjust the centre of the picture between –5 and +5.
Finally press
OK
to confirm and store.
S
S
TV Functions
