54
Notes on recording
Before you remove the MD after the
recording has completed
Make sure that “Edit” has disappeared in the
display.
Before you remove the MD after the
transfer of audio data from your
computer has completed
Make sure that “Edit” has disappeared in the
display, and then press the
x
(stop) button.
If the power source (AC power
adaptor/battery) accidentally
becomes disconnected during
recording
The lid may refuse to open. If this happens, do
not open the lid by force. Do the steps below
instead.
1
Connect the power source (AC power
adaptor/battery) firmly to the recorder.
2
Press the OPEN button to open the lid.
On the MiniDisc cartridge
•
When carrying or storing the MiniDisc, keep
it in its case.
•
Do not break open the shutter.
•
Do not place the cartridge where it will be
subject to light, extreme temperatures,
moisture or dust.
•
Attach the supplied MD label only in the
space designated for it on the disc. Do not
stick it on any other disc surface.
On cleaning
•
Clean the recorder casing with a soft cloth
slightly moistened with water or a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent such
as alcohol or benzene as it may mar the finish
of the casing.
•
Wipe the disc cartridge with a dry cloth to
remove dirt.
•
Dust on the lens may prevent the unit from
operating properly. Be sure to close the disc
compartment lid after inserting or ejecting an
MD.
•
To obtain the best sound quality, use a dry
cloth to wipe the plugs of the headphones/
earphones or the remote control. Dirty plugs
may cause sound distortion or intermittent
breaks in the sound.
Notes on battery
Incorrect battery usage may lead to leakage of
battery fluid or bursting battery. To prevent
such accidents, observe the following
precautions:
•
Install the + and – poles of the battery
correctly.
•
Do not try to recharge dry battery.
•
When the recorder is not to be used for a long
time, be sure to remove the battery.
•
If a battery leak should develop, carefully and
thoroughly wipe away battery fluid from the
battery compartment before inserting new
ones.
Note on mechanical noise
The recorder gives off mechanical noise while
operating, which is caused by the power-saving
system of the recorder and it is not a problem.
To protect a recorded MD
To record-protect an MD, slide open the tab at
the side of the MD. In this position, the MD
cannot be recorded. To record again, slide the
tab back so the tab is visible.
Back of the MD
Recorded material is
not protected.
Tab
Recorded material is
protected.
