25
Setup Menu
The Setup menu is used to change the factory preset settings, etc.
Setting items
Description
Status
Sets whether or not the on-screen display is displayed.
On:
Displays on-screen messages and menus.
Off:
Turns off the on-screen displays, other than certain menus, a message when turning off the power,
and warning messages.
Language
Selects the language used in the menu and on-screen displays.
Menu Position
You can change the position to display the menu on the projection surface.
Bottom Left:
Displays the menu on the bottom left area of the projection surface.
Center:
Displays the menu on the center of the projection surface.
High Altitude Mode
Sets the unit to operate at the prevailing atmospheric pressure.
On:
Use this setting when using the unit at an altitude of 1,500 m (approx. 4,900 ft) or higher.
Off:
Use this setting when using the unit at normal altitudes.
Tip
When this item is set to “On,” the fan noise becomes slightly louder since the fan speed increases.
Remote Start
Sets the Remote Start settings.
On:
You can turn on the power from a PC or a terminal which is connected to a network.
Off:
Turns off the Remote Start function.
Tips
• To use the function, the unit should be connected to the network in advance (page 30).
• To turn on the power with the Remote Start function, a special command should be sent from a PC or
a terminal. For details, consult with qualified Sony personnel.
When the Remote Start is set to “On,” the standby power requirement will increase. When Network
Management is set to “On,” Remote Start is automatically fixed at “Off” and is not displayed in the
menu.
Network Management
On:
Set when connected to the network and continuously communicating with the projector control
equipment.
Off:
Turns off the Network Management function.
When Network Management is set to “On,” the network function is continuously enabled. Set Network
Management to “Off” for normal use. If you set to “On,” the power consumption increases.
Power Saving
Sets the Power Saving mode.
Standby:
If no signal is input for 10 minutes, power is turned off automatically and the projector goes
into standby mode.
Off:
Disables the Power Saving function.
All Reset
All settings are initialized to their factory preset values.
Note
Note
Summary of Contents for VPL-VW870ES
Page 55: ...Sony Corporation ...
