14
Changing the Lens
Position for Rear
Projection (Optical Axis
Angle: 0 degree)
For rear projection, you can set the optical axis angle
to 0 (zero). In this case, you will need to set the lens
position as follows.
You can install the following types of lenses for a zero
optical axis angle.
• Standard lens
• VPLL-ZM102 Long Focus Zoom Lens
• VPLL-FM22 Fixed Short Focus Lens
• VPLL-ZM32 Short Focus Zoom Lens
1
Turn off the power and disconnect the power
cable.
2
Remove the screw from the bottom of the unit by
using a Philips screwdriver .
(single long screw (M3))
3
Slide the top cover (top lens cover) forward, and
then lift it up to remove.
4
Remove the lens hood locking the lens by
loosening the four screws (M3
×
10, with washers)
with a Philips screwdriver.
9
Slide the top cover back until it makes contact
with the rear side.
10
Tighten the screw (single long screw (M3)) in
the bottom base.
Note
• The lens scratches easily, so when handling it,
always place it gently on a stable and level surface in
a horizonal position.
• Avoid touching the lens surface.
