Sony VPL-FHZ700, Operating Instructions Manual

Page: 16 / 63

16
Projecting an Image
Adjusting the tilt of the projector
with the rear feet (adjustable)
When the projector is installed on an uneven
surface, you can adjust using the rear feet
(adjustable). To correct any trapezoidal
distortion of the projected image, use the
Keystone correction feature (pages 16, 32).
You can also broaden the adjustment range
by removing the nuts from the rear feet
(adjustable).
• Be careful not to let the projector down on
your fingers.
• Do not push hard on the top of the projector
with the rear feet (adjustable) extended. It
may cause a malfunction.
• Keystone adjustment is an electronic
correction. Consequently the image quality
may deteriorate.
Displaying a pattern for adjusting
an image
You can display a pattern for adjusting the
projected image with the PATTERN key on
the Remote Commander. Press the
PATTERN key again to restore the previous
image.
Correcting for trapezoidal
distortion of the projected image
(Keystone adjustment)
If the screen is tilted, or you are projecting
from an oblique angle, perform keystone
adjustment.
If the projected image is
trapezoidally-distorted in the vertical
plane
1
Press the KEYSTONE key on the
Remote Commander once or select “V
Keystone” in the Installation menu to
display the adjustment menu.
2
Adjust the value using
V
/
v
/
B
/
b
.
The higher the setting, the narrower the
top of the projected image. The lower
the setting, the narrower the bottom of
the projected image.
Press the RESET key to restore the
projected image before adjustment.
If the projected image is
trapezoidally-distorted in the lateral
plane
1
Press the KEYSTONE key on the
Remote Commander twice, or select
“H Keystone” in the Installation menu
to display the adjustment menu.
2
Adjust the value using V / v / B / b .
The higher the setting, the narrower the
right side of the projected image. The
lower the setting, the narrower the left
side of the projected image.
Notes
Increase setting
Decrease setting