7
j
MUTING key
Mutes the audio output. Press again to
restore the previous volume.
k
BLANK key
Temporarily cuts off the image. Press
again to restore the image.
l
FREEZE key
Pauses a projected image. Press again to
restore the image. Use this key when
inputting a computer signal.
m
D ZOOM (Digital Zoom) key
Enlarges a part of the image while
projecting (page 22).
n
POSITION (Picture Position) key
Not in use for the projector.
o
Infrared transmitter
p
ID MODE switch (page 32)
Set an ID mode of the Remote
Commander. If you assign a different ID
number to each projector when multiple
projectors are used, you can control only
the projector with the same ID mode as
that of the Remote Commander.
q
CONTROL S output terminal
Connect to the CONTROL S input
terminal on the projector with a
connecting cable (stereo mini plug (not
supplied)) to use the Remote
Commander as a wired one.
You do not need to install batteries in the
Remote Commander, as the power is
supplied from the projector.
r
ECO MODE key
Used for energy-saving mode setting
(page 23).
About Remote Commander operation
• Direct the Remote Commander toward the
remote control receiver.
• The shorter the distance between the
Remote Commander and the projector is,
the wider the angle within which the
Remote Commander can control the
projector becomes.
• If there is any obstruction between the
Remote Commander and the remote
control receiver on the projector, the
projector may not be able to receive
signals from the Remote Commander.
