Sony VPL-FE100E, Operating Instructions Manual

Page: 17 / 120

17
(GB)
Connecting with a Computer or a VCR
This section describes how to connect the projector with a computer, VCR,
and external active speakers.
For details on how to connect other equipment, see pages 28 (GB) to 30 (GB).
Also refer to the instruction manuals of the equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out by
the plug, not the cable itself.
Note on the VPL-FE100E model
The optional IFB-X2000E interface board is required for using the VIDEO
connectors.
Note
Set INPUT-A in the SIGNAL SELECT menu to COMPUTER.
For details, see page 27 (GB).
0
INPUT C INPUT B INPUT A VIDEO
AUDIO OUT
REMOTE CONTROL S TRIG DEVICE INDEX
+
–
:
1
VCR
to S VIDEO OUT
to
VIDEO
OUT
to AUDIO OUT
S video cable
(not supplied)
Video cable (not supplied)
Audio cable
(not supplied)
Rear
to a wall outlet
AC power cord
(supplied)
to AC IN
SMF-400 Monitor cable
(5BNC
˜ HD D-sub 15-pin)
(not supplied)
Use the optional ADP-20
Signal adapter (not supplied)
when connecting with a
Macintosh computer.
Computer
Audio cable
(not supplied)
Active speakers
Signal flow
Audio cable
(not supplied)