SmartPanel Projector Driver Application Note
Sony VPL-CX10
© 2001 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107
II. CONTROL WIRING
PROJECTOR CONTROL
RS232
IR/SERIAL
RX
GND
CTS
RTS
TX
+12V
GND
IR/SER
SENSE
Wired Remote to
Control S
1/8" Mini
Female
1/8" Male Mini to 1/8" Male Mini (mono)
(not included)
This section specifies how Wired Remote or IR should be
wired to the projector.
The Wired Remote should be connected to the Sony port
labeled
Control S
. Connection should be as follows:
1. Wire the Panel to a female 1/8" Mini as shown; wire
IR/SER
to
tip
and
GND
to
ring.
Direct wiring to male
1/8” is not recommended as it makes removal of the
Panel for service more difficult.
2.
Attach to the projector port labeled
Wired Remote
using
a male 1/8” mini to male 1/8” mini (not included).
3. Alternately, replace the male to male cable with the
included the IR Emitter and attach it to one of the IR
windows on the projector. The emitter glows red when
IR is emitted so wiring can be verified.
