Adjustment
29
Horizontal registration adjustment
7
Adjust the RH CENT control so that the red and green vertical lines
converge in the center of the screen.
8
Adjust the RH SIZE control (and the RH LIN control, if necessary) so
that the red and green vertical lines converge at the right and left sides
of the screen.
(If necessary, repeat steps
7
and
8
.)
9
Adjust the RH SKEW and RH BOW controls so that the red and green
vertical lines converge in the middle of the screen.
!º
Adjust the RH TILT-1 through TILT-4 controls so that the red and
green vertical lines converge on the corners of the screen.
Adjusting Blue Registration
Proceed to the following blue registration adjustment in the same manner
as with red registration adjustment. Set the R RAS switch to OFF and the
B RAS and G RAS switches to ON.
Vertical registration adjustment
!¡
Press the B CENT button on the control panel and set the H and V
adjustment levels to “00” with the arrow buttons.
!™
Adjust the BV CENT control to adjust the center of the screen.
!£
Adjust the BV SIZE control, and the BV LIN control if necessary, to
adjust the upper and lower sides of the screen.
!¢
Adjust the BV SKEW and BV BOW controls to adjust the middle of
the screen, if necessary.
!∞
Adjust the BV TILT-1 through TILT-4 controls to adjust jthe corners.
Horizontal registration adjustment
!§
Adjust the BH CENT control to adjust the center of the screen.
!¶
Adjust the BH SIZE control, and the BH LIN control if necessary, to
adjust the right and left sides of the screen.
!•
Adjust the BH SKEW and BH BOW controls to adjust jthe middle of
the screen.
!ª
Adjust the BH TILT-1 through TILT-4 controls to adjust the corners.
When the Registration Adjustment is Complete
1
Set the R RAS, G RAS and B RAS switches to ON, and the BAR
switch to BAR.
2
Press the TEST button on the control panel to return to the normal
display.
3
Reinstall the top panel. (See page 17.)
Observe the vertical lines in this part.
