63
Troubleshooting
Troubleshooting
If you have any problem using the UWP series components, use the following checklist.
Should any problem persist, consult your Sony dealer.
Symptom
Meanings
Remedy
The unit does not
turn on.
1)
The polarity orientation of the
batteries in the battery
compartment is incorrect.
Insert the batteries with the
correct polarity orientation.
The batteries are exhausted. Replace the batteries with new
ones.
The battery terminals in the
transmitter are dirty.
Clean the + and – terminals with a
cotton swab.
The batteries
become drained
quickly.
1)
The batteries are exhausted. Replace the batteries with new
ones.
Manganese batteries are
being used.
Use alkaline batteries. The
battery life of a manganese
battery is less than half that of an
alkaline battery.
The UWP series
components is being used
under cold conditions.
The batteries drain quickly under
cold conditions.
The channel cannot
be changed.
An attempt was made to
change the channel by
pressing the SET button only.
Restart the unit while holding
down the SET button. Then
change the channel with the +
and – buttons.
There is no sound.
The channel setting on the
transmitter is different from
that on the tuner.
Use the same channel setting on
both the transmitter and tuner.
The RF indicator on the tuner
does not turn on.
Confirm that the transmitter is
turned on.
The line input is selected on
the transmitter.
2)
Select the microphone input on
the transmitter.
The tuner module is installed
into/uninstalled from the MB-
X6/SRP-X500P while the
MB-X6/SRP-X500P is turned
on.
Turn off the MB-X6/SRP-X500P.
Then, turn it on again.
Summary of Contents for UWP-V1
Page 71: ......