Sony URX-P03D, Operating Instructions Manual

Page: 10 / 19

10
The search for available channels finishes and the
displayed channel is set.
Searching for Active Channels
within a Group (Active Channel
Scan)
You can search for channels in use within the specified
channel group. This is useful when using more than one
receiver in combination with a single transmitter.
Before performing this procedure, select the channel
group.
For details, see “Setting the Receive Channel” (page 9).
1
Press the MENU button to display the RX1 or RX2
menu, and press the + or – button to display the ACT
SCAN screen.
2
Press and hold the SET button for 1 second or longer.
Press and hold until the channel group and “+”
display starts flashing.
3
Press the + button.
The unit starts to scan for active channels in the
selected channel group. When active channels are
found, the first channel number among the active
channels starts flashing on the display.
To display the next active channel number
Press the + button.
To cancel searching
Press the – button. The display returns to the ACT
SCAN screen.
4
Press the SET button when the desired channel
number starts flashing.
The search for active channels finishes and the
displayed channel is set.
Setting the Compander Mode
Depending on the transmitter being used in conjunction
with the unit, changing the compander mode may be
necessary.
You can configure different compader modes for tuner 1
and tuner 2.
• When operating in conjunction with UWP-D series
transmitters, set the transmitters to the same compander
mode.
• No audio will be output if the tone signal frequency is
different due to inconsistencies in compander mode
settings configured on the devices being used together.
1
Press the MENU button to display the RX1 or RX2
menu, and press the + or – button to display the
COMPANDER screen.
2
Press and hold the SET button for 1 second or longer.
The selected item starts flashing.
3
Use the + or – button to select the compander mode,
then press the SET button.
The selected compander mode is configured.
UWP-D: Select this when operating in conjunction
with Sony UWP-D series transmitters.
UWP: Select this when operating in conjunction with
Sony UWP series transmitters.
WL800: Select this when operating in conjunction
with Sony WRT series transmitters.
Transmitter and compander mode
combinations
Configure the appropriate compander mode based on the
transmitters being used.
Audio will not be output if the combination of
transmitters and compander mode settings are not correct.
Notes
Note
Transmitter Compander mode on
unit
UWP-D UWP WL800
UWP-D series
(UTX-B03,
UTX-M03,
UTX-P03,
UTX-B03HR) Compander
mode: UWP-D Yes No No
Compander
mode: UWP No Yes No
Compander
mode: WL800 No No Yes
UWP series (UTX-B2, UTX-H2,
UTX-P1) No Yes No
WRT series (WRT-822, etc.) No No Yes