Sony URX-M2, Operating Instructions Manual

Page: 15 / 20

15 Troubleshooting
Troubleshooting
If you have any problem using the unit, use the following checklist.
Should any problem persist, consult your Sony dealer.
Symptom Meanings Remedy
The channel cannot
be changed. An attempt was made to
change the channel by
pressing the SET button only. Restart the unit while holding
down the SET button. Then
change the channel with the +
and – buttons.
There is no sound. The channel setting on the
transmitter is different from
that on the tuner. Use the same channel setting on
both the transmitter and tuner.
The RF indicator on the tuner
does not turn on. Confirm that the transmitter is
turned on.
The tuner module is installed
into/uninstalled from the
MB-X6/SRP-X500P while the
MB-X6/SRP-X500P is turned
on. Turn off the MB-X6/SRP-X500P.
Then, turn it on again.
The transmitter is not
transmitting signals, or the
transmission output is weak. Confirm that the transmitter is
turned on. Alternatively, reduce
the distance between the
transmitter and tuner.
The compander mode
setting on the transmitter is
different from that on the
tuner. Configure the transmitter’s
compander mode to a setting that
matches this unit.
The transmitter is muted.
Press the POWER/MUTING
button on the transmitter to
release the muted state.
The sound is weak. The attenuation level on the
transmitter is too high. The input level of the transmitter
is low. Press the – button on the
transmitter in attenuation level
setting mode to decrease the
attenuation level.
The volume on the amplifier
or mixer is low. Adjust the volume.
The compander mode
setting on the transmitter is
different from that on the
tuner. Configure the transmitter’s
compander mode to a setting that
matches this unit.