25
AC IN
Preparation
Connection
Preparation
Connect the printer to your computer using the computer’s interface cable. Then
connect the printer to a wall outlet. The interface cable differs according to your
computer. Before connecting, refer to the manuals of the computer and other
peripherals.
Notes
• Before connecting, turn off the power of the computer and the printer.
• Disconnect the power cord from the printer.
• Connect the power cord last.
• Use an interface cable matching the printer’s connecter (Centronics).
• To use the printer in ECP mode, use an interface cable in conformity to IEEE
STD 1284 such as Hewlett Packard C2951A.
1
Make sure that the computer and the printer are turned off.
2
1
Insert the interface cable to the printer’s connector.
2
Fasten the clamps
at both sides of the connector to secure the cable.
3
Connect the cable to the computer.
4
Connect the AC power cord to the AC IN connector of the printer and then to
a wall outlet.
AC IN connector
AC power cord (supplied)
To a wall outlet
(Rear)
Interface cable (Hewlett
Packard C2951A, etc.)
AC IN
DIP SW
OFF
DIP SW FUNCTION TABLE
NO FUNCTION
SW-ON SW-OFF
1
2
3
4
5
6
7
8
PAPER
GAMMA
POSTFEED
COMMAND
RESERVED
RESERVED
TYPE
TYPE
TYPE
TONE
TONE
TONE
ON
OFF
D890
D880
ON
Summary of Contents for UP-D890
Page 21: ...21 その他 ...
