12
Loading Paper Roll and Ink Ribbon
Op
er
at
ion
9
Close the front door.
Loading the ink ribbon
1
Open the side door.
2
Remove the ink ribbon holder.
After removing the ink ribbon holder, do not insert
your hand into the opening in the unit. Touching the
protrusions or movable parts inside the unit may result
in bodily injury or malfunction of the unit. In
particular, touching the thermal head when it is hot
immediately after printing may result in burns.
3
Open the ink ribbon holder cover.
4
Detach the white spool of the ink ribbon from the black
spool.
5
Gently unravel the ribbon without loosening it, and
place it in the ribbon tray.
Place the white spool in the front holder and the black
spool in the rear holder as shown. Be sure to press
down on the side of the black spool in which the IC
chip is embedded until it snaps into place.
If there are any creases in the ink ribbon, straighten
them out.
Note
Note
IC chip
Summary of Contents for UP-CX2
Page 25: ...Sony Corporation ...
