5
c
Viewfinder front-rear positioning lever
Locks the front-rear position of the viewfinder.
Loosen the lever to adjust the viewfinder position.
d
Viewfinder left-right positioning ring
Locks the left-right position of the viewfinder.
Loosen this ring to adjust the viewfinder position.
For details about adjusting the viewfinder position, see
“Attaching a Viewfinder” (page 9).
e
FILTER LOCAL button
While holding this button depressed, press either of the filter
select buttons to select the built-in optical filters.
f
Filter select buttons
You can switch the built-in ND and CC (color temperature
conversion) filters by pressing the select buttons while holding
the FILTER LOCAL button depressed.
Pressing the left button selects the available ND filters (clear,
1/4ND, 1/16ND, 1/64ND) in sequence.
Pressing the right button selects the available CC filters
(3200K (clear), 4300K, 6300K, CAP) in sequence.
g
Assignable switch
You can assign a function using the menu displayed on the
viewfinder screen.
h
MENU SEL (menu select) knob/ENTER button (rotary
encoder)
To select settings from menus displayed on the viewfinder
screen (by turning the knob) and to confirm settings (by
pressing the button).
i
Rod clamp
Use to attach and detach rods with a diameter of 15 mm.
When attaching rods, secure them in position by turning the
rod lock lever clockwise.
When detaching rods, turn the rod lock lever counterclockwise
to loosen the lever.
Pull the lever out and turn it to a position that facilitates
operation if its position makes it hard to turn. Once you have
decided on a position, push the lever back into place.
• Do not overtighten the rod lock lever without a rod inserted.
• Always attach and detach the rods two at a time. A single
rod cannot provide a secure lock.
j
STATUS/CANCEL switch
STATUS:
Displays the status information of the unit on the
display.
CANCEL:
When the menu is displayed on the viewfinder
screen, you can cancel any changed settings or return the
display to the previous menu.
k
DISPLAY switch
The functions of the DISPLAY switch are as follows:
DISPLAY:
Characters and messages showing the camera
settings and operating status may be displayed on the
viewfinder screen.
OFF:
Status messages will not appear on the viewfinder
screen.
MENU:
Menus for camera settings will be displayed on the
viewfinder screen.
Rear
a
Tally lamp and switch
ON:
The tally lamp lights when a tally signal is input to the
connected camera control unit or a call signal is generated
in response to pressing the CALL button.
OFF:
The tally lamp is prevented from lighting.
b
CCU (Camera Control Unit) connector (optical/
electrical multi connector)
Connect a UHCU-8300 8K Camera Control Unit using an
optical/electrical multi cable.
c
SDI 1 (serial digital interface 1) connector (BNC-type)
For 12G-SDI (4K VF/4K PROMPTER), 3G-SDI, HD-SDI, or
HD PROMPTER signal output.
d
SDI 2 (serial digital interface 2) connector (BNC-type)
For HD-SDI signal output.
It functions as an input connector when used as HD TRUNK
IN.
Notes
To loosen: Turn
counterclockwise
To tighten: Turn
clockwise
b
c
Operation panel
d
a
fe
Connector panel
