7
Connector panel
a
INTERCOM1 and 2 (intercom 1 and 2) connectors
(XLR-type)
Used for input and output of intercom audio signals when a
headset is connected.
The INTERCOM 1 connector can be used for communication
over the engineer line even when the power is off, as long as
the power LED is lit in red.
b
EARPHONE jack (stereo mini jack)
For connecting an earphone or headset to hear the intercom
audio.
Adjust the audio level on the <EARPHONE> page of the
OPERATION menu.
c
REMOTE connector (8-pin)
Reserved for future use.
Standalone operation is not supported.
Do not connect any remote control device, such as an RCP or
MSU, to this connector.
d
DC OUT (DC power supply output) connector (4-pin)
To supply power to devices such as a wireless receiver
(optional) (max. 0.5 A).
e
USB connector (for connecting a USB drive)
Connect a USB drive to save or load the settings data file.
For details, see “Using a USB Drive” (page 50).
f
TRACKER connector (10-pin)
For external interface, such as intercom and tally.
g
RET CTRL (return control) connector (6-pin)
For connection to a CAC-6 Return Video Selector.
h
DC IN (DC power supply input) connector (XLR 4-pin)
Used for connection to the AC-DN10A AC Adaptor to supply
power to the camera.
i
AUDIO IN (audio input) CH1 and CH2 connectors (XLR
3-pin) and switches
Connect audio signals. An input select switch and microphone
power switch are provided for each channel.
CH1 (channel 1) audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN CH1 connector.
LINE:
When a line-level signal source is connected
MIC:
When an external microphone is connected
CH2 (channel 2) audio input select switch
Set to the appropriate position according to the equipment
connected to the AUDIO IN CH2 connector.
LINE:
When a line-level signal source is connected
AES/EBU:
When a digital audio signal is connected (The
signal must be in synchronization with the camera output).
MIC:
When an external microphone is connected
Microphone power switches
When a microphone is connected to the corresponding AUDIO
IN connector, set whether or not to supply power to the
microphone.
+48V:
To supply power at +48 V.
OFF:
Not to supply power.
(No function has been assigned to the lowermost position. No
power is supplied to the microphone.)
To 12 V power, contact a Sony sales representative
or Sony service representative.
j
MONI (serial digital interface) connector (BNC-type)
For HD-SDI output.
For details about signal settings, see “Setting the Camera
Outputs” (page 17).
k
SYNC (sync output) connector (BNC type)
To output the analog signal.
This also outputs an HD-Y signal, HD-SYNC signal, or an SD-
SYNC signal that is the same as the signal output from the VF
connector, depending on which of these you have selected in
the menu.
For details about signal settings, see “Setting the Camera
Outputs” (page 17).
l
PROMPTER (prompter signal output) connector (BNC-
type)
For output of the prompter signal (valid only when a camera
control unit is connected).
Note
b
c
d
e
f
g
h
i
j
k
a
l
m
n
o
Note
CH1 audio input select switch
Microphone power switches
CH2 audio input select switch
AUDIO IN CH2 connector
AUDIO IN CH1 connector
