– 11 –
KV
-J14P2S/J51PF2S
RM-869
c
Anode button
2-7. PICTURE TUBE REMOVAL
2
Using a thumb press down, then pull up the rubber cap firmly in the direction
indicated by the arrow
b
.
3
When one side of the rubber cap is separated from the anode button, the
anode-cap can be removed by turning up the rubber cap and pulling it up in the
direction of the arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-cap with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode
cap to the metal chassis, CRT shield or carbon paint on the CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
Cushion
4
A board
6
C board
7
Deflection yoke
8
Four screws
(Tapping screws)
3
Anode cap
2
Speaker
block assy
1
Two screws
(
+
BVTP 4
×
16)
1
Two screws
(
+
BVTP 4
×
16)
2
Speaker
block assy
a
a
b
b
