— 19 —
KV-27FV15/29FV10/29FV15/29FV15C/29FV15K
3-3. FOCUS
1.
Input Monoscope signal.
2.
Set user controls to normal.
3.
Set Video mode to STANDARD.
4.
Set the PICTURE to maximum.
5.
Adjust FOCUS control for best picture at 325 MARK.
3-4. SCREEN (G2)
1.
Input signal from the pattern generator.
2.
Set the user controls to NORMAL.
3.
Attach the G2-Jig to the C Board.
4.
Adjust RCUT, GCUT, BCUT, and SBRT in service
mode with an oscilloscope so that voltages on the red,
green, and blue cathodes are 170 + 2 V DC.
5.
Observe the screen and adjust SCREEN (G2) VR to
obtain the fairly visible background of dot signal.
6.
Push the TEST +JUMP (+ Channel) to cut off the signal,
thenthe screen is bright or dark. Brightness of raster
must be increased when adjusting.
7.
Adjust screen VR until the screen is just cut off, or
scarcely lights up. A signal cannot be seen when the
brightness of the raster is high.
8.
Push the JUMP again to release the cut off.
3-5. WHITE BALANCE ADJUSTMENTS
NO.
Disp.
Item
All Models
24
RDRV
Red Drive
31
25
GDRV
Green Drive
31
26
BDRV
Blue Drive
31
27
RCUT
Red Cut-off
7
28
GCUT
Green Cut-off
7
29
BCUT
Blue Cut-off
7
38
SBRT
Sub Bright
7
1.
Input an entire white signal.
2.
Set to Service adjustment Mode.
3.
Set DCOL to "0"
4.
Set the PICTURE and BRIGHT to minimum.
5.
Adjust with SBRT if necessary.
6.
Select GCUT and BCUT with
1
and
4
.
7.
Adjust with
3
and
6
for the best white balance.
8.
Set the PICTURE and BRIGHT to maximum.
9.
Select GDRV and BDRV with
1
and
4
.
10. Adjust with
3
and
6
for the best white balance.
11. Reset DCOL to "1".
12. Write into the memory by pressing
then
**.
325 MARK
LION MARK
35 MARK
35
325
NN
NN
pedestal
NN
GND
170 + 2 Vdc
